eufy IndoorCam C120 setup guide

What this camera needs

Enable RTSP / NAS in the app and verify continuous stream availability on your firmware.

This guide is based on manufacturer documentation, reviewed on 13 October 2026. This model has not yet been tested hands-on with Agentinosaurus.

Prepare your IndoorCam C120

1. Set up the camera in the eufy app and connect it to your local Wi-Fi.
2. Open camera settings → General → Storage → RTSP / NAS. Enable the feature and copy the address provided by the app.
3. Use that generated address in Agentinosaurus. Test that the feed remains available during quiet periods as well as motion.

Choose the camera stream

Copy the complete local stream address supplied by the camera app. There is no single address to guess for this setup.

These instructions cover the named powered IndoorCam models. Battery eufyCam products can provide motion-triggered recordings rather than an always-available stream; they are not interchangeable.

Add it to Agentinosaurus

Your camera supplies the video. Station runs on a separate computer and connects that video to your workspace. Keep both on the same trusted local network; Ethernet and Wi-Fi can be mixed as long as the devices can reach each other.

1. Install Station, pair it with your workspace and add your OpenAI API key.
2. Create an Event describing what you want to watch for.
3. Choose Add camera and your paired Station. Try camera detection first; if it does not find the camera, enter its local stream address and camera credentials manually.
4. Assign your Event and choose Only on movement or Continuous. Try a simple visible action, then check Messages and the camera’s monitoring status.

If the camera does not connect

Check the local IP address, camera login and streaming port. A cloud-app password is not always the camera password. Reserve the camera’s address in your router so it does not change after a restart.

Guest Wi-Fi and client isolation can stop devices from reaching each other. A camera that works in its manufacturer’s phone app may still need local streaming enabled.

Test the same address in VLC on the Station computer. If it also fails there, check the camera configuration first. If it works there but not in Station, check Station diagnostics and try an enabled H.264 substream.

Keep credentials private. There is no need to forward camera ports on your router or expose the stream to the internet.

Explore guides