Skip to guide
AgentinosaurusLearn
$AGSAUROpen workspace
Browse guides
← Supported cameras

Camera support

Hikvision cameras

Find your Hikvision model and connect its local video stream to Agentinosaurus.

Before you connect

Channel 102 selects the substream. Recorder channel numbering differs: 201 normally refers to channel 2’s main stream; verify your recorder configuration.

  1. Activate the camera and create its password with Hikvision’s setup tool or camera interface.
  2. Find its IP address and configured RTSP port. If using discovery, enable the camera’s ONVIF service and create an ONVIF user where required by its firmware.
  3. Use channel 101 for a standalone camera’s main stream. Use the configured port if it differs from this example.

Explore guides

DS-2CD2347G2-LU →The cited datasheet covers the (B) revision of this 4 MP turret camera. Verify the revision on your device label.

Manufacturer documentation

Check the original instructions for your hardware revision and firmware.

Hikvision: getting an RTSP stream ↗DS-2CD2347G2-LU datasheet ↗

$AGSAUR · Solana · x402

The Agents in this guide are metered in $AGSAUR.

Every observation, question and webhook an Agent runs is settled in $AGSAUR over x402 on Solana — no cards, no subscription, no invoice. Station operators earn the same token for keeping the network awake. Launching soon.

Contract address Launching on Solana — CA drops with the token
@agntinosaurus Token story →