Skip to guide
AgentinosaurusLearn
$AGSAUROpen workspace
Browse guides
← Supported cameras

Camera support

ANNKE cameras

Find your ANNKE model and connect its local video stream to Agentinosaurus.

Before you connect

Replace main with sub to select the substream. Match the camera’s model number and hardware generation to the manual, since C500 and C800 are product families.

  1. Activate the camera and set its password. ANNKE’s C500/C800 guide uses SADP to find the camera on your network.
  2. Check that the camera and Station can reach each other, then enter the camera IP address and login.
  3. Use the documented main-stream address below; if you use a recorder, consult its channel-specific address instead.

Explore guides

C500 →Use the C500/C800 bullet-camera manual linked below for the matching hardware revision.C800 →C800 covers multiple hardware generations. Check the full model on the label before applying the linked bullet-camera instructions.

Manufacturer documentation

Check the original instructions for your hardware revision and firmware.

ANNKE C500 and C800 setup manual ↗ANNKE: common camera questions ↗

$AGSAUR · Solana · x402

The Agents in this guide are metered in $AGSAUR.

Every observation, question and webhook an Agent runs is settled in $AGSAUR over x402 on Solana — no cards, no subscription, no invoice. Station operators earn the same token for keeping the network awake. Launching soon.

Contract address Launching on Solana — CA drops with the token
@agntinosaurus Token story →